KitchenAid KHDD2 38510 Návod k použití

Instructions for useGBIT

10Gas connection ISO 7/1ISO 228/1 (FR)WARNING! This operation must be performed by a qualifiedtechnician.• The gas supply system must comply with loc

11The cook top is designed to be built in to a work surface as shown in the figure.Before installing the cook top, install the gasket seal around the

Note: Refer to the table on page 6 to ensure the correcttype of injector is to be fitted.Traditional burners (T)1. Remove the cap (A).2. Remove the sp

Before any cleaning and/or maintenanceoperation, disconnect the hob from powersupply and wait until it is cold.To keep the hob in perfect condition, r

If the hob is not working properly work throughthe this guide before contacting our CustomerCare Centre.The burner does not ignite, or the flame isuns

400010780632Printed in Italyn05/15Whirlpool Europe - Socio UnicoViale G. Borghi, 27 - 21025 Comerio (VA)Phone 0332.759111 - Fax 0332.759268www.whirlpo

Product description and symbols 4Using the burners 4Practical advice on using the hob 5Positioning the pan supports 5Hood and cabinetry clearances (mm

1. Removable grids2. Auxiliary burner3. Rapid burner4. Auxiliary burner control knob5. Rapid burner control knobProduct description and symbolsqwterCo

Read the instructions to get the best out of yourhob.- Use pans with a similar diameter to the burner(see the table on this page)- Use flat bottomed

This appliance is not provided with a combustionproduct discharge. It is recommended that it beinstalled insufficiently aerated places, in terms ofthe

7CategoryII2H3+Refer to the injector table of your CountryElectric supply:220-240 V ~ 50/60 Hz 0,6WInjectors tableType of gas usedTy p e o f burner

• In the event of prolonged usage, additionalventilation may be required (opening a windowor increasing the extration speed of the hood).Warning• Ke

EC Declaration of conformityThis appliance has been designed, constructed and marketed in compliance with:- safety requirements of "GAS" Dir